EUROTRON UniGas 1000 COMBUSTION GAS ANALYSER
Compact and ergonomic, fits in your hand. Easy to use with large multiline display. Ambient CO safety monitoring.
Proprietary design water trap. Draft & differential pressure meter. Low cost tool for boiler maintenance.
|
Display : LCD display 40 x 58 mm with backlight device Sensors : O2, CO, CO2 Smoke index Easy replaceable gas sensors Pressure / Draft input Infrared port : compatible with HP82240B cordless printer Self-diagnosis : sensors efficiency test / display diagnostic messages Calibration : automatc, at instrument switch-On Printer : built-in impact Printer report header : 4 programmable lines Printer power supply : from the analyser battery pack Operating temperature : -50°C to +450°C Storage temperature : -20°C to +60°C Power supply : high capacity Ni-MH rechargeable battery pack/external battery charger Charging time : 8 hours at 90 % with instrument Off Battery life : 6 hours (typical) continuous use (without printing and backlight) Dimensions : 115 x 90 x 330 mm Weight : 1,1 kg with battery and printer |
Easy replaceable gas sensors UniGas 1000 uses long life low maintenance sensors for O2 and CO.
Standard Report of Calibration Each instrument is factory calibrated and certified against Eurotron Standard to ensure traceability, and shipped with a Report of Calibration.
Rechargeable battery operations Ni-MH rechargeable batteries provide longer field use. Flue gas analyser and internal printer is powered by unique batteries. Charger is supplied as standard.
Built-in impact printer The instrument is available with or withhout a built-in rugged impact printer. Certainly more readable, long time and heat resistant than the thermal printout on chemical paper.
Pressure / Draft input Differential pressure input to verify : draft, gas pipework leak with pressure decay programme, gas vflow pressure, pressure in combustion chamber, ΔP on filters and fan, pressure switches calib ration.
Smoke index measurement is performed by using the optional external hand pump. The results can be stored in the internal memory and printed on the report.
Ambient CO safety monitoring A procedure can be selected to monitor the CO in ambient air using the internal sensors. An internal program allows the CO max measurement in atmospheric boiler check.
Parameters
O2 : 0 - 25 %
CO : 0 - 4000 ppm
CO2: 0 - 99,9 %
Temp. air : Pt100; -10 - 100°C
Pressure/Draft : -10 hPA to 100 hPa
Excess air : 1,00 - infinity
Efficiency : 1 - 99,9%
Standard package
Unigas 1000 basic unit
Battery charger
Differential pressure sensor
Infrared port for HP thermal printer
Rubber holster
Instruction manual
Eurotron calibration certificate
Bercu nv
Noordschippersdok 13 T. +32 3 225 32 73 ejb@bercu.be
B-2060 Antwerp F. +32 3 234 18 49
Belgium
www.bercu.be www.bercu.com Copyright @ Bercu nv. All rights reserved.